A powdered metal (PM) assembly often asks a lot of a single joint. The weld has to suit both materials, hold the assembly’s dimensions, and carry the intended load. The right welding approach depends on the part, its materials, and how the finished assembly will be used.
While CD welding works well for wrought materials, this process is particularly suited for PM materials. At Process Equipment Company (PECo), we use capacitor discharge (CD) welding for PM to PM and PM to wrought steel assemblies. Our CD welding process works very well with powdered metals of low, medium, and high densities as well as parts with high-carbon mixes.
How CD welding works on PM assemblies
CD welding uses electrical energy stored in capacitors to create a strong, solid-state weld. An intense, rapid release of electric current through a weld projection is followed by controlled pressure, forging the parts together. Because the discharge is so short, the heat-affected zone (HAZ) stays small, helping preserve the surrounding material and avoiding thermal distortion.
Subsequent tempering pulse(s) support welding of high-carbon and high-alloy materials. These pulses reheat the weld area, lowering hardness to acceptable levels and increasing ductility and toughness. We develop the weld parameters around the material and application.
The weld itself takes less than 50 milliseconds. Typical part-to-part production cycles are 6–30 seconds, depending on the application. PECo will design the weld projection geometry based on the design requirements, and we will determine cycle time and weld performance for your assembly during process development.
What to include in your inquiry
- Both material grades, including PM density
- The joint you plan to weld and the geometry available for the weld and tooling
- The load, torque, sealing, and dimensional requirements of your application
- Any coatings, plating, oil, or other surface conditions
- Expected production volume and cycle time constraints
Suitable applications can accommodate oil-covered parts without a separate washing step. We evaluate surface conditions during process development.
How we test the weld
We establish quality assurance around each project’s requirements. Depending on the application, testing includes destructive methods such as microstructural analysis, tensile and compression strength testing, and bend testing, along with non-destructive testing (NDT) such as leak testing. Weld data logging records weld energy, weld current, pre-weld height, temper energy, temper current, and set-down to support quality control. We agree on the test method and acceptance criteria with you, based on your needs.
To discuss a PM assembly, request a quote or contact us. Tell us about your materials, part or assembly, production volume, and any specific requirements. Our team will coordinate file formats and transfer after your initial inquiry. You can also explore our CD welding capabilities.
